公司名称：山东非凡新型建材有限公司

　　1、XPS挤塑板必须确保在自然环境条件下陈化满足42天的要求，如工期较紧，则应采取在60℃蒸汽养护条件下陈化5天的备用措施。以免因XPS板陈化期不足，导致上墙后继续收缩，造成抗裂保护层及装饰面层开裂、翘曲、变形。
　　1, XPS Extrusion board must ensure that under natural conditions of aging, to meet the requirements of 42 days, such as the duration is tight, should be taken at 60 degrees steam curing conditions, aging 5 days of standby measures. The XPS board so as to avoid ageing, resulting in the wall continues to shrink, causing crack protective layer and a decorative surface layer cracking, warping and deformation.
　　2、XPS挤塑板粘贴时，平整度调整应采用橡皮锤敲击的方式，不得采用上下、左右错动的方式调整，以免因挤塑板的错动致使粘结剂溢进板间的缝隙内，形成冷桥，将对外保温系统的保温效果造成较大的负面影响。
　　2, XPS extruded plate paste, smoothness adjustment should adopt rubber hammer way, using and so on dislocation mode shall not be adjusted, so as to avoid the dislocation resulting in extruded plate binder spilled into the plate in a gap between the formation of cold bridge, the external insulation insulation effect system caused great negative impact the.
　　3、XPS挤塑板粘贴施工时，为保证阳角的垂直度，在阳角处施工时，应使XPS板适当超出墙面一定距离，待XPS板全部贴贴完后，再进行统一弹线后切割，并打磨平整。
　　3, XPS board paste construction, to ensure the verticality of yang angle, Yang corner construction, should be appropriate beyond a certain distance from the wall plate XPS, XPS board to be posted after all, then the unified elastic line after cutting and polishing.
山东非凡新型建材有限公司
　　联系人：高经理
　　邮箱: 285132697@qq.com
电话：400-009-6717
　　手机: 15165012015
QQ: 285132697
　　地址：山东省济南市黄河大厦4楼
　　诺商基于多年的优化经验和品牌基础推出的诺商商道系统，诺商信息您身边的互联网专家！